September 27, 2020

Explain Leak testing System using example.

Application:-Make a leak test system. Write PLC program for leak test system using ladder diagram language.

Diagram:-










Explanation:-

As per the above application, there is one pipe in the system. We need to check its leakage by applying pressure up to 4- 5 bar. For leakage testing, the first pipe will be put into the fixture and one side pipe will be blocked completely. From the other side, the pressure will be applied.

The transmitter will read the pressure. Once the pressure achieved into the pipe, the system will close the inlet pressure valve and hold pressure into the pipe. If there is no pressure drop for 1 minute, the pipe is ok and if the pressure drop measured during 1 minute, the pipe is leaked.


PLC program:-

Write the ladder program for the above application using ladder diagram language. Here for ladder logic, we can use any supported PLC system like S7-1200, S7-300, S7-1500 or any other PLC which can support this instruction. For PLC logic we need digital inputs and outputs.

Digital inputs:-

Start Button=I0.0

Digital Output:-

Inlet Valve=Q0.0

Ok lamp=Q0.1

M Memory:-

MD24= Set Pressure

MD20=Actual Pressure

Network 1:-Inlet valve for air supply


 




Network 2:-Inlet valve reset when pressure achieved







Network 3:-Indication timer for ok pipe






PLC program Explanation:-

In network 1, the inlet valve (Q0.0) will on when the start button (I0.0) is pressed. Here we used set coil so the output will be set after the start button pressed.

In network 2, the inlet valve will be off when Actual pressure (MD20) is greater or equal to set pressure (MD24).

In network 3, if the pressure will not drop from the pipe for 60 seconds, ok indication lamp will be on.


1 comment:

  1. Quality content. Thanks for sharing your blog with us that was really amazing. keep sharing your efforts with us.
    PLC HMI Training in Lahore

    ReplyDelete